S SonDurak New Member May 12, 2014 #1 HELLO THERE; CAN I MODEL THE 2 BEAMS SEEN IN THE ATTACHED PICTURE AS A SINGLE (BROKEN) BEAM? THANKS...
HELLO THERE; CAN I MODEL THE 2 BEAMS SEEN IN THE ATTACHED PICTURE AS A SINGLE (BROKEN) BEAM? THANKS...
L Levent Özpak New Member May 12, 2014 #2 Hi, you can draw K117-K96 beams with the Curvilinear Beam command by giving the number of curved beam points 1 in the Beam Settings dialog.
Hi, you can draw K117-K96 beams with the Curvilinear Beam command by giving the number of curved beam points 1 in the Beam Settings dialog.
German 
French 
Spanish 
Portuguese 
Italian 
Arabic 
Russian 
Japanese 
Turkish