beam error

[cem]

In the attached project, I am getting CAS error on some beams. Even if I have increased the beam dimensions, the same problem persists. In some projects, I also get similar errors in beams with one end on the column and the other on the curtain. I'm glad. Thanks in advance.

 

[Levent Özpak]

There is an error in the continuous basic data entry under P04P05 in the project. When entering continuous foundations S27-S27, click to create the common node of Panels P04-P05. In addition, a piece of K78 beam remained at the right end of the K34 beam on the ground floor. When these errors are corrected and analyzed, the problems with beams and curtains are solved. You can also review the attached document for the solution of the B problems in the columns.

 

[cem]

I did the same thing you said, I edited the prj again and had it analyzed. the same problem continues again...

 

[Levent Özpak]

I did exactly what you said, I rearranged the prj and had it analyzed. The same problem still persists...

I forgot to write it in my previous message.... In addition, from the Reinforcing Selection dialog, 10 pcs for beam stirrups You also need to mark the diameter of the reinforcement.