Basically I'm getting ZG error I couldn't figure it out

O

osm392

New Member
I GET ZG ERROR DUE TO THE BASIS OF MY 3-STOREY PROJECT, BECAUSE THE FLOOR CLASS IS ZD. I WOULD LOVE IT IF YOU CAN HELP ME URGENTLY FOR THESE TWO DIFFICULT THINGS ON MY FLOOR FLOOR. THE ANALYSIS OF THE PROJECT AND THE GROUND SURVEY REPORT ARE ATTACHED. I WISH YOU A GOOD DAY.
You do not have permission to view link Log in or register now.
 
Re: I GET A ZG ERROR ON BASIS, I CAN'T SOLVE IT Hello My Suggestions: -- When I make an account (ZG) it does not give a ground error. --Correct errors in geometry control, --Make columns given as P12-P51 curtains,(dimensions are not appropriate) --Correct (B) errors, --There are places with insufficient slab thickness, Ünver ÖZCAN
 
Re: BASIC I GET ZG ERROR I CANNOT SOLVE IT Hello, you are getting negative ground stress error on the ground. The resulting negative ground tension can be neglected because it is a combination of 0.9G and a small value. Analysis settings->Base/Soil ->You can deactivate the check for negative bearing capacity on raft foundations. You have group curtains that do not save from the curtain tilt design. You can make your L type group curtains C type or increase the curtain thickness. You need to increase the depth of the beam with Nmax error. A different type of reinforcement was used in the flooring you are having trouble with. You need to remove the battery. I wish you a good work
 
Re: I FOUNDLY GET A ZG ERROR I CANNOT SOLVE ANY KIND THANK YOU VERY MUCH I FIXED ALL THE PROBLEMS. I WISH YOU A GOOD DAY.
 
You must log in or register to reply here.
Back
Top