German 
French 
Spanish 
Portuguese 
Italian 
Arabic 
Russian 
Japanese 
Turkish How can we solve the parts that do not save the carrying capacity without making improvements?
You do not have permission to view link
Log in or register now.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Basic bearing solution
- Thread starter MrtGrsl
- Start date
Re: Basic bearing capacity solution. Hello
All of them need to be improved. Your ground value is too low. Check if they have given soil safety stress according to the old method. The soil must have bearing strength (qt). If they have given the correct value, you should make ground improvement and increase your ground value by at least 50%."MrtGrsl":2f3l7lj6" said:How can we solve the underlying bearing capacity without recovery?
Re: Basic bearing capacity solution. First of all, thanks for your answer. Of course, the improvement will be in all. It was a project. But the contractor was busy and we went back to the beginning. Since we saved it without healing before, it forces it to be like that again. Even though I tried to distribute the load as much as possible, I reduced it to 13.5 values, but there were friends who said that it would save with this value. or if there are different methods that can be done, I wanted to ask experienced friends.