Basic Beam Expansions

A

akcanakpinar

New Member
Good afternoon, take it easy, I had a question about the foundation beam expansions: In continuous foundations placed at a non-right angle, the foundation beam expansions should come and go from column to column, but in some cases, they go on and on, on the right or left, as follows img]http://f1208.hizliresim.com/10/w/ccfwy.jpg[/img] Or like this
ccg30.jpg
It is possible to fix this manually, but is there a solution in terms of waste of time, I searched a lot in the program but could not find it, I would be very happy if someone can help
 
Re: ABOUT BASIC BEAM EXTENSIONS Hello, The situation you wrote is the possibility of the program. Namely; Examine the attached representative plan image... The TK02 foundation ends at the point where the representative reinforcements I have shown in red end, not in the S01 column. In short, there is a concatenation situation that arises from the continuous base width. When you consider the element middle axes, the basic expansions are formed as you specified. Good work
 
Re: ABOUT FOUNDATION BEAM EXTENSIONS If you want to draw your foundations with small angles, in the Reinforced Concrete/Parameters/General Reinforced Concrete Parameters Dialog -Continuously accept beams with small angle difference- line. You can enter the angle value.
 
Re: ABOUT BASIC BEAM EXTENSIONS Hello; It is a very correct possibility to extend the beam reinforcements to the edge of the other beam in the plan image added by Levent Bey and similar situations. Finishing the beam reinforcements at the column boundary causes many problems and errors in practice. Best regards.
 
I have the same problem in my project. And in the beam opening, the console is 255 cm, don't you think it's abnormal, or does it change depending on the angle between the beams?
 
You must log in or register to reply here.
Back
Top