German 
French 
Spanish 
Portuguese 
Italian 
Arabic 
Russian 
Japanese 
Turkish I open a project that I drew in ide cad architecture in ide cad static, but the load library is complex, when I analyze the whole building, it turns out to be problematic. I think it is due to the load library. How do we load the normal loads of the static program, not this load library one by one. I searched the forum but couldn't find any information on the subject. How do I ensure the compatibility of the architectural and static program with each other. If you could help with this situation, I would greatly appreciate it.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
architectural static program compatibility
- Thread starter tasarim
- Start date
HakanŞahin
Administrator
Could you add the project?"tasarim":1z44gvpo" said:ide cad architecture, I open a project that I drew in ide cad static, but the load library is complex, when I analyze the whole building is problematic. I think it is due to the load library. I do not use this load library one by one, but the normal loads of the static program. how to install. I searched the forum but couldn't find any information on the subject. How can I ensure the compatibility of the architectural and static program. I would appreciate if you could help with this.
Levent Özpak
New Member
Wall unit volume weight in architecture There is no general setting for static project solution except wall unit volume weight is also important if -Automatically take from idecad architectural walls- option for beams and slabs is checked in Analysis Settings/Other tab. Other than that, check your load information such as slabs, beams, etc. However, we cannot give a definitive answer to your problem without adding your project."tasarim":2n77fap7" said:What kind of setting should I make in the architectural program before I transfer a project drawn in the architectural program to the static program. I couldn't find much information about it. I would be glad if you could help with that.