Analysis and Drawings of Loads Transferred to Beams?

[armedesign]

Hello, the drawings and analyzes of the loads transferred to the beams of the project we made in idecad, as in sap2000, with triangular trapezoidal spread etc. Can we get your drawings? In the project I have done, I need to make and see the distribution and calculations of the hurdi and branch floors according to the loads on the beams. Is it possible for me to examine the entire system axle by axle?

 

[cassabotanic]

Loads are calculated and transferred using the finite element method. Loads transferred in the report section are shown with drawings.

 

[admin]

In load analysis in ideCAD, each slab is solved as a shell system supported by its edges. Then, the external reactions of these supported nodes (points on the perimeter beams) are calculated. These calculated reactions (translation in z degrees of freedom, rotation in x, y degrees of freedom) are acted on the relevant points of the beams as a single load. Thus, a solution can be made in a way that is not limited to rectangular tiles. You can examine these calculated single loads in the 3D frame-load analysis section.

 

[armedesign]

Thank you for your answers.. is it possible for us to open them in detail as if they are drawing the mold plan and see the page loadings? I couldn't find it in the help section of the program.

 

[admin]

You can't see it the way you mentioned. Since there will be thousands of single point loads in the system, it is very confused in the form of a mold plan. If you transfer your system to the SAP2000 program, the floor loads are also transferred as individual loads on the beams. By examining the transferred .mdb file in Access program or sap2000, you can see the numerical values of the loads transferred to each beam one by one.