German 
French 
Spanish 
Portuguese 
Italian 
Arabic 
Russian 
Japanese 
Turkish vforvendett4
New Member
Hello, what is the meaning of the 10?8 addition phrase in my project?
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Additional stirrup in the middle of the beam
- Thread starter vforvendett4
- Start date
Levent Özpak
New Member
Re: Additional stirrup
Hello, "10fi/8-additional" stirrup- (indirect support) in the beam connection is the suspension reinforcement specified in TS 500 article 8.1.2, Figure 8.1. The drawing of the suspension reinforcements on the left side in the 3D picture is the situation that occurs in the construction site display. Consider the beam detail drawings. Good work"vforvendett4":zv8hx62o" said:Hello, what is the meaning of the 10?8 addition phrase in my project?
vforvendett4
New Member
Re: Additional stirrups
Thank you. I looked at the figure (Figure 8.1), as far as I understand, additional stirrups will be thrown in the area where the beam is stuck, and the spacing of the stirrups will decrease to 4 or 5 cm. Good work"Levent Özpak":11yksfz6" said:Hello "10fi/8-additional" stirrup is the suspension reinforcement specified in TS 500 article 8.1.2, Figure 8.1 (indirect support) at the beam-beam junction. Drawing the axle reinforcements on the left side in the 3D picture is the situation that occurs in the construction site display. Consider the beam detail drawings. Good work"vforvendett4":11yksfz6" said:Hello, what is the meaning of the 10?8 addition phrase in my project?