add wind load

[hakan_sb]

Dear ideyapı family, first of all, I would like to congratulate you for the meticulousness in the new version. It was a nice work, but now I have a 22-storey building project in my hand, I would like to define the wind load in addition, can you help me?

 

[HakanŞahin]

Hello, After calculating the wind loads acting on the floors, enter each of them in the Wind X and Wind Y cells in the Analysis/Story Parameters dialog, on the Wind-Soil tab. After the analysis, the program will consider the wind loads as TS500 load combinations and use them in the reinforced concrete design in case of negative loading.

 

[kyuceturk]

So does it just take tf as a unit? That is, I use it as kN, but I changed the unit to tf and entered the menu again, and there was no change in the load. Thank you

 

[HakanŞahin]

So, does it only take tf as a unit? That is, I use it as kN, but I changed the unit to tf and entered the menu again and there was no change in the load. Thank you

Units in floor parameters are fixed. tf and cm...