aCAD import and geometric control errors.

[ottomancagatay]

Attached is a project I transferred from aCad, I encounter the same errors every time. Object on top of each other, incorrect column-beam intersection, short object, small angle object, although I always pay attention to these errors, especially when making the beams, they occur one after the other. How can I solve this? Where am I wrong? I would be glad if you help.

 

[Levent Özpak]

Hello, *First of all, the overlapping object message in the geometry control is a warning, not an error. This warning is ignored if the object of interest actually makes a small angle with the X or Y axis. Apart from this, data entry in the project by taking into account the following issues can help reduce errors; *Check that the information you import is correct. (Are the axes drawn at a right angle, are their dimensions suitable for the project, etc.) *Place the column joint points at the axis intersections. *Make sure that the -Divide by intersections- line in the beam auxiliary toolbar is active so that the beam-to-beam connections can be made automatically. *When drawing beams between columns, make sure that the beam's nodal point is at or above the column corner. Good work