About TS500 11.3.2 error in threaded flooring

[fibonacci]

Hello everyone, I just joined the forum and the ide family. I'm still at the beginning stage, I want to progress by correcting my mistakes, so I need your valuable comments. I am getting 11.3.2 error on Gear tiling in geometry control. I think I have met the conditions of the relevant article, since the floor is longer than 4 m, I threw 2 beams across. Normally, it is sufficient to throw 1 beam transversely according to ts. In order that when a beam is thrown, this beam does not coincide with the middle of the main beam, I thought it appropriate to throw 2 cross beams, close to the support points of the main beam, instead. Am I thinking wrong? Is the error caused by the program due to this? Thank you in advance for your support.

 

[NYILMAZ]

Re: TS500 11.3.2 ERROR IN GEAR FLOOR RIGHT. The warning message here is related to the height of the floor teeth. You have entered a tooth height of 30 cm. This thread height is not suitable for this opening. You need to increase. For example, when you make 32 cm, there is no problem. In addition, if you are going to make a flooring in this way, it will be sufficient to remove the intermediate rib from the middle and just do it. Essentially your problem with height here comes from the secondary rib. The slab long span is about 610 cm. When you distribute the ribs in the short direction, you will not encounter the height problem for this. But you cannot meet the TS500 conditions due to the secondary rib you throw in the long direction. If you throw ribs in the long direction then you need to put intermediate ribs. In this system, when you throw the secondary ribs parallel to the short side like yours, you do not need to throw a distribution rib (intermediate rib). The slab length (rib length) here does not exceed 4 m. Thus, you do not have a thickness problem. Good luck with. Good work. N. YILMAZ

 

[fibonacci]

I understand, thank you very much for the detailed explanation.. Good luck with your effort..