A3 irregularity help

[coskun3561]

Hello there; When I get a report in my project, A3 irregularity does not appear in the offset and irregularity controls. However, in the tdy 2.3.irregular buildings section, my building fits the definition of figure 2.3 A3 irregularity. Why doesn't A3 see the irregularity? Am I misinterpreting? Also, in the irregularity report, there is the statement of user inspected for each floor under the irregularity A3 and irregularity A2. Are we going to do the irregularity checks ourselves? I'm sending the project to [email protected], it's 3 MB. Respects

 

[Levent Özpak]

Hello, Whether there is an irregularity of type A2-A3 in the structure is under user control. In order for the A3 irregularity to appear as present in the report, the relevant line must be marked in the Analysis Menu/Floor Parameters/Irregularities Tab. In case of A2-A3 type irregularity, you can examine the attached document to make the necessary control.