(4/5)R must be taken error I'm getting

[BahadırC]

Good day everyone. I am doing a reinforced concrete project at school, but in my project I get the error (4/5)R should be taken in the shear overturning moment part. When I say (4/5)R in the analysis settings section, this error is corrected, but the selected R=5.60 and our teacher said that it should be 7. How can I fix this error.

 

[Levent Özpak]

Re: (4/5)R Error

Good afternoon everyone. I am doing a reinforced concrete project at school, but I am getting the error (4/5)R must be taken in the shear overturning moment part of my project. When I say apply (4/5)R in the analysis settings, this error is corrected, but the selected R = 5.60 and our teacher says it should be 7. How can I fix this error. When the analysis is done, the program automatically multiplies the entered R value by (4/5) and gives it as the Selected R. This is not an error. It is the value it should be.

 

[BahadırC]

Re: (4/5)R Error

Good afternoon everyone. I am doing a reinforced concrete project at school, but the curtain tipping moment in my project I get the error (4/5)R must be taken in the analysis settings section. When I say apply (4/5)R in the analysis settings section, this error is corrected, but the selected R=5.60 and our teacher says it should be 7. When the analysis is done by selecting the "Apply 4/5 R" option in the Analysis Settings, the program automatically multiplies the entered R value by (4/5) and gives it as the Selected R. This is not an error. It is the value it should be.

Here is our teacher (assistant, he doesn't know very well, I think ) says the chosen R=7.

 

[sereze]

In the case where we say apply (4/5)R, does it perform the 4/5R verification and apply it if necessary, or does the porogram perform 4/5R anyway?

 

[YasinTezel]

Hello, Examine the Curtain tipping torque control report and select this option if necessary. If you choose the option, it will apply in all cases.

 

[sereze]

Thank you Mr. Yasin

 

[BahadırC]

Hi, review the Curtain tipping torque control report and select this option if necessary. If you choose the option, it will be applied in all cases.

It is required and I choose it, but our teacher says it should be R=7. He wants me to correct the error but I couldn't find any other way.

 

[YasinTezel]

Hello. The application conditions of this substance are related to the parameter I have shown in the picture in the analysis settings. Even if there is only one screen in your project when the option is selected 4.3.2.4. The terms of the article apply. If you do not select the option, this control is performed only in fully curtained systems. (A12 and A13 Carrier systems) If your system is a curtain + frame system, you can cancel the 4/5R reduction status by removing this option. Our recommendation is to work with the option selected.