mehmet ergin
New Member
The slenderness ratios in the upper and lower heads of the scissors.... İzmir YTE R&D The same scissors with MKA Software save with 2L 70/7 Section It does not give slenderness ratio error on printouts. I can't remove the slenderness error when I solve it with ide. You have to enlarge the section. MKA stated that the slenderness ratio should be different for multi-storey buildings. ALSO, AKHİSAR MUNICIPALITY DID NOT ACCEPT THE PROJECT BECAUSE THERE ARE NO COMBINATION AND RESOURCE ACCOUNTS IN SHEAR ACCOUNTS. waiting for your help. But this job went to another office just for this reason.. best regards..