Stair and section

[demir]

Good luck with. I want the staircase to appear on the 1st floor plan, but not to the attic when I cut it, that is, not to be visible on 1 floor.

 

[Zeynep Aladağ]

Hello, First take your Ladder somewhere outside of your plan. Select your ladder and make it 2D with the smash object command. Select your staircase drawing and make a block for easy transport and placement later on. Place your staircase drawing in its place on the plan. Since it is 2 dimensional, it will not come out in cross-sections. I wish you good work..

 

[memox85]

IF THE LADDER IS THE SAME AS THE LADDER LOWER FLOOR, YOU CAN GIVE THE LEVEL LEVEL AS THE LOWER FLOOR. BECAUSE THE STAIRS ARE THE SAME ON THE LOWER FLOOR, THEY OVERCOME AND THE STAIRS ARE LEFT ON THE 1st FLOOR.