Analysis Error

D

damlatpz

New Member
Good day, while doing risky building analysis, idecad turns itself off as soon as it starts analysis. Has anyone encountered this problem, can you help?
 
As you said, I first took a normal analysis and then I did a risky building analysis, but the problem is the same. I attached the file.
 
Building importance coefficient zero (0) is entered in the project. Enter 1 and perform normal analysis and risky building analysis. The problem will be fixed. Note: K1, K2 and K18 beams are not connected to S16 column. (Incorrect column-beam intersection warning in geometry control) Good work
 
That's why they said that I should get the building importance coefficient (I) 0 from the provincial directorate and load 1.4g+1.6q on the beams and take I as 1 and get the rbte analysis of the columns and floors. I will try again, thank you very much, good work
 
You must log in or register to reply here.
Back
Top